This system provides simplified controls and automation, reducing operator training requirements. To maintain greater process control, the heater exhaust temperature is held constant, and the temperature setpoint is low to minimize stress. To vary heat, simply adjust airflow. Focused convection nozzles direct heat exactly where it’s needed. During the removal cycle, the vacuum pickup automatically lifts the component from the board when the solder reflows, and then shuts off the heat. The time used in the removal cycle is stored and displayed as a guide for establishing the minimum time to reattach a similar component. The Remote Controller provides the main interface between you and the QX2, and features: Start/Stop button, Airflow Control, Temperature Display, Attach and Remove Modes, and Time Control. The Board Holder is self-centering which accommodates and holds securely PCBs in a size range from 2” x 2” to 14” x 18”.
Input Voltage: 90-132VAC, 50/60 HzConvection System: Heater 550W. Rated current 5A. Airflow 20-50 l/min. Source Temperature Default Setpoint 350°C, Range (programmable) 250-450°C.Preheater: Heater 950W. Rated current 8.5A. Heating surface 6”x 6”. Resulting board temperature 90-120°C.Board Holder: Minimum board size 2” x 2”. Maximum board size 14” x 18”.
|GoKimco Part #:||OK-AC-BH|
|Manufacture Part Number (MPN):||AC-BH|
|Country of Manufacture||China|