Satisfaction Guarantee
-
Single Workstation Continuous Monitor
Continuously monitors the path-to-ground integrity of one operator, one ESD worksurface, and the electrical ground used to by the monitor. -
NEW Monitored Ground Terminal
Provides a verified ground point for mats, carts, tools, and other items. Connect with the 09842 Multi-Ground Hub. -
NEW Light Tower Jack
Connects with 19332 Light Tower Accessory -
NEW Auxiliary Jack
Connects with 19333 Power Relay Accessory -
Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor -
AC Outlet Monitor Circuit
Verifies the wiring of an AC outlet and continuously monitors its path-to-ground integrity; fulfills the ANSI/ESD S6.1 section 6.3.1 requirement -
Park Delay Timer and Park Snap
Indicates the 8 second delay to disconnect and park the operator wrist cord without creating a false alarm -
Embedded Relay Terminal
Activates when a failure is reported by the monitor. Integrates with electronic locks, lights, and buzzers. -
Mat Monitor Switch
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface -
Audible Alarm Adjustment
Sets the audible alarm volume from loud to louder -
Enclosure with Mounting Tabs
Installs in workbench and equipment environments -
Single-Wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0 -
1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components -
<50 Millisecond Alarm Response Time
Identifies failures and intermittencies -
Continuous Visual and Audible Alarms
Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs -
Calibration Verification
Use the Desco 98221 Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations -
NIST Calibrated with Certificate Included
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. -
100-240VAC Input with North American Power Cord
Works with standard electrical systems in North America, Japan, and Asia -
Made in the United States of America
This item is made and stocked in Chino, CA. - Suggested replacement for the Desco 19321